Bus Wash Equipment with Rollover 2 Brushes
Request a Quote
Bus wash equipment with 2 rollover brushes are used to clean two sides, the head, and back side of busses. This bus wash system is ideal for washing vehicles where the length does not exceed 18,000mm, the height does not exceed 4,200mm, and the width is 2,700mm. This system is capable of washing up to 15 buses per hour. During the washing process, the bus remains motionless, and the machine will move the brushes over and around the vehicle. Shown below are some basic parameters.
ParametersModel | CB-720 |
Dimension | L*W*H: 2880mm×5120mm×5900mm |
Assembling Range | L≤24000mm×W 6800mm |
Moving Range | L 1800-2400mm × W 6800mm |
Voltage | AC three-phase four-wire system Voltage AC380V50Hz |
Water Supply | DN25mm water flow rate≥120L/min |
Ground Flatness | Deviation≤10mm |
Washing method | 1 rollover |
Applicable Vehicles | Container truck, box truck, bus |
Applicable Car Dimension | L≤18000mm×W 2700mm×H≤4200mm |
Washing Time | 12-15 cars/h |
- The fully automatic PLC electronic control system improves the security.
- A one-click washing method simplifies operation.
- The galvanized bus wash system frame is corrosion resistant.
- There is no need for extra wiping after the washing process.
Standard Devices |
Frame |
Brush system |
Lateral brush motor |
Drive motor |
Water pump |
Equipment data intellectualization |
Self-diagnose system |
Related products
Send Message
Most Recent
More
Other Products
Videos