Concrete Mould Release Agent
Concrete Mould Release Agent, MNC-T6 Type
MNC-T6 typeconcrete mould release agent is applied to various types of template used atroom temperature, including wood, metal, polyester or plywood.
Concrete mould releaseagent features little dust and no fouling on the mould, easy to dismantle, rustresisting, mould clean, extending the mold life, cheaper than motor oil andother mold release products, and no erosion on product surface, mould, rubberseal and rubber boots. By forming an isolation membrane, it can fight againstrain pouring with no influence on stripping effect.
Coverage
This product coverage ranges from 60 to 120 ㎡/㎏ when sprayed with suitable equipment, the size of which differs from thetemperature and the amount of water added.
How to use concrete mould release agent
1. Before initial dose, you must clean such devices ascontainers, pressure tank, piping and nozzle. Checking nozzle frequently andcleaning pressure tank quarterly is necessary to keep spray finishing evenlyand prevent long-term water accumulation.
2. In winter or low temperature, you should heat mixing water and fully mix itwell for use rather than use steam directly for mixing.
3. For the initial use, weight ratio of concrete mould release agent should beadjusted to one to two. According to mold finish, the proportion of addingwater gradually increases to 1 to 2.5, 1 to 3, 1 to 3.5 and 1 to 4.
4. You should always keep mold surface clean with treatment of rust removal andpolishing.
5. Warm-up before using cold mould or improving mold release concentration mustbe done to avoid mold sticking and barrel edge spalls, etc.
6. Before spraying, the pressure of pressure tank should be adjusted to no lessthan 0.4MPa to reach the mist effect by spraying.
7. You should correctly and evenly spray the release agent. If it appears thephenomenon of spray uneven or tainted spray, artificial brush is a must.
Packaging
Each barrel of concrete mould release agent weighs
